Metrohm tiamo 2.3 (process analysis) - Manual (Page 1406)

6.6 Subwindow Titrants/Solutions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1390 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
￭ Drag the column title:
Moves the column to the required location
If the contents of a field is larger than the column width then the whole
contents will be shown as a tooltip if the mouse cursor is kept on the
field.
Functions
The menu [Edit] below the solution table contains the following menu
items:
New… Adds new solution manually (see Chapter 6.6.2.2, page 1390).
Delete Deletes selected solution (see Chapter 6.6.2.3, page 1390).
Properties… Edits selected solution (see Chapter 6.6.3.1, page 1392).
Column display… Defines the columns for the solution table (see Chapter 6.6.2.4, page 1391).
Print (PDF) Shows the solution table as a PDF file (see Chapter 6.6.2.5, page 1391).
6.6.2.2 Add new solution
Menu item: Configuration ▶ Titrants/Solutions ▶ [Edit] ▶ New…
Solutions in non-intelligent exchange units (EU) and dosing units (DU)
without data chip must always be added manually to the solution table
with Edit
▶ New... ▶ Exchange unit or Edit ▶ New... ▶ Dosing unit.
The Properties window then opens automatically for editing the solution.
After the Properties window has been closed, the solution will be entered
in the solution table. The parameters can be altered at any time with
[Edit]
▶ Properties...
Note
Solutions in intelligent 806 Exchange Units (IEU) or 807 Dosing Units
(IDU) with data chip need only be manually added and configured
when they are fitted to devices that cannot read out the data automati-
cally (e.g. Titrino, 700 Dosino).
6.6.2.3 Delete solution
Menu item: Configuration ▶ Titrants/Solutions ▶ [Edit] ▶ Delete
With [Edit] ▶ Delete, the solution selected in the solution table is
deleted.