Metrohm tiamo 2.3 (process analysis) User Manual

Page 65

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

2 General program functions

tiamo 2.3 (for Process Analysis)

￭￭￭￭￭￭￭￭

Designation

Description

Commands

.SAN

Current, absolute swing angle of
the robotic arm in ° (entry upon
ending the command)

MOVE, SWING

.SLO

Electrode slope of the sensor used
for the command (in % for pH
sensor or mV for ISE sensor) or
electrode slope calculated from
the calibration (for STDADD and
CAL LOOP)

DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS T,
MEAS Conc,
STDADD, CAL
LOOP, DOS, ELT
LOOP

.SME

Start measured value (measured
value after processing the start
conditions) in the unit of the
measured value

DET, MET, SET,
KFT, KFC, BRC,
STAT

.SPO

Current external position (entry
when ending the command); 0
means invalid position

SWING

.STC {x}

Concentration of standard x (1...
50) used for the command

CAL LOOP Opt

.STE

Start temperature (temperature
after processing of the start condi-
tions) in °C

DET, MET, SET,
KFT, KFC, BRC,
STAT

.STY

Type of stop with which the com-
mand was stopped: 1 = normal;
0 = manual or after error

DET, MET, SET,
KFT, STAT, MEAS,
CAL Cond, CAL
MEAS, CAL Spec,
STDADD, DOS,
ELT MEAS

.SVA

Start volume absolute (volume
that was added according to the
start condition "start volume") in
mL

DET, MET, SET,
KFT, STAT

.SVM

Start volume measured value (vol-
ume which was added according
to the start measured value given
in the start conditions) in mL

DET, MET