Metrohm tiamo 2.3 (process analysis) - Manual (Page 878)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
862 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Designation Description
.EVT End volume (total dosed volume at the end of the
command) in mL
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in mV
.FP{x}.TEM Temperature for the fixed endpoint × (1…9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1…9) is reached
.FP{x}.VOL Volume for the fixed endpoint × (1…9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.DVT dV/dt for the last measuring point on the measuring
point list (SET, KFT, STAT, DOS) or drift for the last
measuring point on the measuring point list in µg/min
(KFC)
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MA.MEA Maximum measured value in the unit of the measured
value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MA.VOL Volume at maximum measured value in mL