Metrohm tiamo 2.3 (process analysis) - Manual (Page 1319)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1303
Absolute position
Move to an absolute position, whereby the stepping motor moves to
the value defined under Distance/Angle.
End position
Move to the end position of the stepping motor.
Reset
A reset is carried out on the terminal the motor is connected to. While
doing so, the LEDs of the terminal will shortly flash, afterwards it could
be necessary to reference anew.
Distance
Distance to be moved to.
Visible only in cases of stepping motors where Type = Linear drive.
Range -214783647 ... 214783647 mm
Default value 0 mm
Angle
The angle to be moved to.
Not visible in cases of stepping motors where Type = Rotary drive.
Range -214783647 ... 214783647 °
Default value 0 °
Note
The moving direction of the stepping motor depends on the algebraic
sign of the value for Distance or Angle:
￭
≥0: Move in positive direction.
￭
<0: Move in negative direction.
Start delay
Waiting time in seconds or minutes before the initiated action is started.
Range 0 ... 999999
Default value 0
Selection s | min
Default value s
Timeout
Time in seconds or minutes within which the action must have run
through completely. If this is not done after the maximum waiting time
has expired, the status of the stepping motor will be set to ERROR.