Metrohm tiamo 2.3 (process analysis) - Manual (Page 611)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 595
.GP.TEM Temperature for the Gran endpoint in °C
.GP.TIM Time in s until the Gran endpoint is reached
.HP{x}.MEA Measured value for the HNP × (1…9) in mV (HNP =
half neutralization potential)
.HP{x}.TEM Temperature for the HNP × (1…9) in °C
.HP{x}.TIM Time in s until the HNP × (1…9) is reached
.HP{x}.VOL Volume for the HNP × (1…9) in mL
.IGF Initial gas flow (measured value at the time of the start
of the command) in mL/min
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
on the measuring point list
.LP.DME Measured value differential for the last measuring point
on the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MA.MEA Maximum measured value in the unit of the measured
value
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is reached
.MA.VOL Volume at maximum measured value in mL
.MI.MEA Minimum measured value in the unit of the measured
value