Metrohm tiamo 2.3 (process analysis) - Manual (Page 1364)

6.3 Configuration data ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1348 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
6.3.2 Backup/Restore
6.3.2.1 Backing up configuration data automatically
Dialog window: Configuration ▶ File ▶ Backup ▶ Automatically ▶ Backup configu-
ration data automatically
Automatic backup
on | off (Default value: off)
If this check box is activated, then the configuration database is saved
automatically to the defined backup directory at the desired time interval.
The entire configuration database (including method groups and meth-
ods) is saved at this time.
If this check box is deactivated then the following parameters cannot be
edited.
Last backup
Display of date and time of the last configuration data backup.
Next backup
Date and time at which the next backup is to be carried out. The
opens the window Next backup to select the date (see Chapter 2.5.1,
page 89).
Default value Last backup + 1 month
Interval
Entry of the time interval after which an automatic backup will take place.
After each automatic or manual backup the interval entered here will be
added to the date of the Last backup and shown in the field Next
backup.
Range 1 ... 999
Default value 1
Selection day(s) | week(s) | month | year(s)
Default value month
Backup directory
Selection of a pre-defined backup directory (see Chapter 6.2.3.2.1, page
1338).
Note
Make sure that you have read and write permission on the selected
directory.