Metrohm tiamo 2.3 (process analysis) - Manual (Page 1299)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1283
5.6.10.5.2 WAIT - Properties
Dialog window: Method ▶ WAIT ▶ Properties... ▶ WAIT - 'Command name'
Command name
Name of the command.
Input 25 characters
Wait
Selection of the following options:
Selection Stop track and waiting for [Continue] | Stop
all tracks and waiting for [Continue] | Waiting
time
Default value Stop track and waiting for [Continue]
Stop track and waiting for [Continue]
If this option is enabled, the track containing the WAIT command is
stopped and a message is displayed. The method run can only be con-
tinued by pressing [Continue].
Stop all tracks and waiting for [Continue]
If this option is enabled, all tracks currently running are stopped and a
message is displayed. The method run can only be continued by press-
ing [Continue].
Waiting time
If this option is enabled, the method run will be continued automati-
cally after this waiting time. The text defined below under Message is
displayed during the waiting time.
Waiting time
This parameter can only be edited for Wait= Waiting time
Range 0 ... 9999.9
Default value 0
Selection s | min
Default value s
Message
The message defined here is displayed while the track is stopped or during
the waiting time. The text editor for entering or changing the message is
opened with or by double-clicking into the text field (see Chapter
2.5.2, page 90). The formula editor can also be called up inside the text
field (see Chapter 2.4, page 29).
Input Text (unlimited)