Metrohm tiamo 2.3 (process analysis) - Manual (Page 1020)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1004 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS Conc and can be used in formulas under the designa-
tion 'Command name.Variable designation':
Designa-
tion Description
.BLV Blank value of the sensor used for the command (only
for ISE sensors)
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s
.EME End measured value (measured value after processing of
the command) in the unit of the measured value
.ENP Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point on
the measuring point list
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point of the
measuring point list in the unit of the measured value