Metrohm tiamo 2.3 (process analysis) - Manual (Page 1692)

8.4 Manual control - Functions ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1676 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Range 0 ... 100 Pixels
Default value 0 Pixels
[Start]
Start measurement of the intensity.
[Stop]
Stop measurement of the intensity.
8.4.5.4 Measure - Sample spectrum
Program part: Manual control
Here a sample spectrum can be measured and displayed.
Note
Before a sample spectrum can be measured, a reference spectrum has
to be recorded in a determination by a spectrometer.
The parameters Start wavelength, End wavelength, Integration
time, Averaged spectra and Smoothing are read out of the refer-
ence spectrum and displayed, they cannot be modified.
[Start]
Start measurement of the sample spectrum. Only active, if a reference
spectrum is available.
[Stop]
Stop measurement of the sample spectrum.
8.4.6 Process analysis functions
8.4.6.1 Process analysis functions - Overview
Program part: Manual control
If in the subwindow for the device selection, an IO controller or a stepping
motor is selected, then the device tree will be extended by the connected
inputs and outputs and the stepping motors.
Process analysis functions
The functions depend on the selected entry in the device tree:
￭ (see Chapter 8.4.6.2, page 1677)
￭ (see Chapter 8.4.6.3, page 1678)
￭ (see Chapter 8.4.6.4, page 1684)
￭ (see Chapter 8.4.6.5, page 1685)
￭ Stepping motors
￭ Multi-port valve