Metrohm tiamo 2.3 (process analysis) - Manual (Page 1316)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1300 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
5.6.11.6 STEPPING MOTOR
5.6.11.6.1 STEPPING MOTOR - Overview
Dialog window: Method ▶ STEPPING MOTOR ▶ Properties... ▶ STEPPING MOTOR
- 'Command name'
Devices
This command can be executed with the Stepping Motor Controller.
Appearance
The command has the following appearance:
Mode of operation
Stepping motors can be actuated with time controls.
Parameters
The parameters for the command STEPPING MOTOR are configured on
the following 2 tabs:
￭ General
￭ Stepping motors
Command variables
The following command variables are generated in the method run by the
command STEPPING MOTOR and can be used in formulas under the
designation 'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
5.6.11.6.2 STEPPING MOTOR - General
Tab: Method ▶ STEPPING MOTOR ▶ General
Command name
Name of the command.
Input 25 characters