Metrohm tiamo 2.3 (process analysis) - Manual (Page 1460)

6.8 Subwindow Colorimetric sensors ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1444 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Calibration interval
Validity of the calibration in days. If a value is entered here then the date
for the next calibration will be adapted automatically. The days are
monitored, e.g. the calibration becomes invalid when the date changes
and not at the time time of day that calibration took place.
Only editable for Calibration data monitoring = on, otherwise inactive.
Range 0 ... 999 Days
Default value 999 Days
Next calibration
Date on which the next calibration is to be carried out. The date can be
selected by pressing in the dialog window Select date. After the date
has been entered the value for Calibration interval will be automatically
adapted.
Only editable for Calibration data monitoring = on, otherwise inactive.
Default value Calibration date+ 999 days
Message
Message by e-mail
on | off (Default value: off)
The message is additionally sent to the address defined under [E-mail...]
if this check box is activated.
Editable only if Calibration data monitoring = on, otherwise inactive.
[E-mail...]
[E-mail...] opens the Send e-mail window (see Chapter 2.6.1, page 92).
Active only if Message by e-mail = on.
Acoustic signal
on | off (Default value: off)
If this check box is activated, an acoustic signal will be emitted in addition
to the message defined above.
Editable only if Calibration data monitoring = on, otherwise inactive.
Action
If during calibration data monitoring it is found that its validity has
expired, then one of the following actions will be triggered automatically
at start test:
Editable only if Calibration data monitoring = on, otherwise inactive.