Metrohm tiamo 2.3 (process analysis) - Manual (Page 1632)

7.20 IO controller ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1616 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Default value
Display of the default value the outputs takes directly after starting and
exiting the program. The default value is also set after an error or when
canceling the method.
Lastly used value
on | off (Default value: off)
If this option is enabled the lastly set value is used as default value on the
analog output.
Enter the default value.
Range -214783647 ... 214783647
Default value 0
7.20.8 Properties - Controller
All defined controllers are listed in a table on the Controller tab. The set-
tings can be modified for each controller.
Controller name
Display of the controller name.
Controller type
Display of the controller type.
Controlled variable
Display of the controlled variable.
Actuating variable
Display of the actuating variable.
[New]
Opens a menu in order to create a new controller.
This button is active only if there is still room on the PLC for at least one
controller.
The menu [New] contains the following menu items:
Direct controller Creating a new controller of the Direct controller type.
2-point controller Creating a new controller of the 2-point controller type.
PID controller Creating a new controller of the PID controller type.
PWM controller Creating a new controller of the PWM controller type.