Metrohm tiamo 2.3 (process analysis) - Manual (Page 1180)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1164 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Identifica-
tion Description
.FIN Command status; 1 = Command has been ended
at least once, 0, invalid (variable not available) =
Command has never been ended
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the measured
value
.ITE Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value × (1...3) for the last measuring point
of the measuring point list
.LP.DVT dV/dt for the last measuring point in the measuring
point list (SET, KFT, STAT, DOS) or drift for the last
measuring point in in the measuring point list in
µg/min (KFC)
.LP.EXx External value × (1...3) for the last measuring point of
the measuring point list
.LP.MEA Measured value for the last measuring point in the unit
of the measured value of the measuring point list
.LP.TEM Temperature for the last measuring point of the meas-
uring point list in °C
.LP.TIM Time in s until the last measuring point in the measur-
ing point list is reached
.LP.VOL Volume for the last measuring point in the measuring
point list in mL
.MR.MRC Correlation coefficient for mean dosing rate for the
whole range
.MR.MRS Standard deviation for mean dosing rate for the whole
range in mL/min
.MR.MRT Mean dosing rate for the whole range in mL/min.
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in the measuring point list
.SLO Electrode slope of the sensor used for the command (in
%)