Metrohm tiamo 2.3 (process analysis) - Manual (Page 1233)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1217
5.6.7.5 PUMP
5.6.7.5.1 PUMP - Overview
Dialog window: Method ▶ PUMP ▶ Properties... ▶ PUMP - 'Command name'
Command for controlling pumps connected to or built into the Sample
Processor.
Devices
This command can be executed with the following devices:
Sample Processor: 730, 778, 789, 814, 815, 855, 864
Appearance
The command has the following appearance:
Parameters
The parameters for the command PUMP are configured in the following
dialog window:
￭ PUMP - Properties
Command variables
The following command variables are generated in the method run by the
command PUMP and can be used in formulas under the designation
'Command name.Variable designation':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
not ever been started
.FIN Command status; 1 = Command has been ended at
least once, 0, invalid (variable not available) = Com-
mand has never been ended
5.6.7.5.2 PUMP - Properties
Dialog window: Method ▶ PUMP ▶ Properties... ▶ PUMP - 'Command name'
Command name
Name of the command.
Input 25 characters