Metrohm tiamo 2.3 (process analysis) - Manual (Page 1019)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1003
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 929).
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 929).
[Delete]
Deletes the external measured value selected in the table.
5.6.4.9 MEAS Conc
5.6.4.9.1 MEAS Conc - Overview
Dialog window: Method ▶ MEAS Conc ▶ Properties... ▶ MEAS Conc - 'Command
name'
Command for Concentration measurements (direct measurement).
Instruments
This command can be executed with the following devices:
Titrando: 808, 809, 835, 836, 857, 904, 905, 906, 907
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Conc are configured on the fol-
lowing 3 tabs: