Metrohm tiamo 2.3 (process analysis) - Manual (Page 852)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
836 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
The conditions for stopping the titration are defined on this tab.
Stop time
Stop when the entered time has elapsed since the start of the titration.
off means no stop.
Range 1 ... 999999 s
Selection off
Default value off
5.6.3.6.7 KFC - Conditioning
Tab: Method ▶ KFC ▶ Properties... ▶ Conditioning
Command name
Name of the command.
Input 25 characters
Conditioning
on | off (Default value: on)
Enable/Disable the conditioning. If the conditioning is disabled, the follow-
ing parameters are not visible.
Start drift
The determination can only be started when the currently measured drift
is less than the start drift entered here. In such cases, the Status in the
Run subwindow displayed on the Single determination or Determina-
tion series tab will then switch to COND READY.
Range 1 ... 999 µg/min
Default value 20 µg/min
Drift correction
If this parameter is set to automatic or manual the drift correction ( =
Drift value × Time for drift correction) caused by empty consumption
during titration is deducted from the total consumption. The Time for
drift correction is the period between end of conditioning and end of
titration.
Selection automatic | manual | off
Default value automatic
automatic
The drift lastly determined during conditioning will be used as drift
value.
manual
The drift value defined under Drift value will be used.