Metrohm tiamo 2.3 (process analysis) - Manual (Page 1306)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1290 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Off
Sets the digital output to off after the start delay has expired.
Timer
Sets the digital output to on after the Start delay has expired and
then back to off after the Working time has expired.
Set default value
Sets the digital input back to the set value in the configuration.
Start delay
Waiting time in seconds or minutes before the initiated action is started.
Range 0 ... 999999
Default value 0
Selection s | min
Default value s
Working time
The time for which the digital output can be set to ACTIVATED can be
specified in seconds or minutes when Action = Timer. It is reset to
DEACTIVATED after the working time has expired.
Range 0.01 ... 999999
Default value 0
Selection s | min
Default value s
End delay
Waiting time after the working time has expired
Range 0 ... 999999
Default value 0
Selection s | min
Default value s
Parameters
Parameter 1
The meaning of Parameter 1 depends on the Type of the digital output
that has been set.
When Type = Stirrer: stirrer output in %, pulse duration dependent on
Parameter 2.
Range -214783647 ... 214783647
Default value 100