Metrohm tiamo 2.3 (process analysis) - Manual (Page 1324)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1308 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
5.6.11.8.2 CONTROL - Properties
Dialog window: Method ▶ CONTROL ▶ Properties... ▶ CONTROL - 'Command
name'
Command name
Name of the command.
Input 25 characters
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection IO Controller
Default value IO Controller
Control parameters
Controller name
Selection of the controller output which is to be controlled.
Selection 'Controller name' | not defined
Default value not defined
Controller type
Display of the type of the selected controller output.
Selection Direct controller | Two-point controller | PID
controller | PWM controller