Metrohm tiamo 2.3 (process analysis) - Manual (Page 1312)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1296 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Table
An analog output is parameterized in every line of the Analog outputs
table. The calculated or fix value is written directly to the selected analog
output in the run.
One port can not be used more than once within a block.
If a command block originates from a different device, the Port descrip-
tion of which does not exist on the currently selected device, then the
affected lines will be presented in red script.
Functions
Moves the selected line up.
Moves the selected line down.
[New]
Opens the dialog window Analog output # in order to edit a new line
(see Chapter 5.6.11.4.4, page 1296).
[Properties]
Opens the dialog window Analog output # in order to edit the selected
line (see Chapter 5.6.11.4.4, page 1296).
[Delete]
Deletes the selected line.
5.6.11.4.4 ANALOG OUT - Analog output #
Dialog: Method ▶ ANALOG OUT ▶ Analog outputs ▶ Properties ▶ ANALOG OUT -
Analog output #
Port description
Selection of the analog output. The analog outputs of the selected device
are available. No port can be selected if not defined is selected in the
Device name field.
Type
Shows the type of the analog output.
Action
Selection Set value | Set default
Default value Set value
Set value
Writes the content of the field Value on the analog output.