Metrohm tiamo 2.3 (process analysis) - Manual (Page 787)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 771
only shown for Stop criterion = time. The selection inf. stands for infin-
ite.
Titrando, 855
Range
0 ... 999 s
Default value 10 s
Titrino
Range
0 ... 999 s
Default value 10 s
Selection inf.
Stop time
The titration is stopped if the stop time defined here has elapsed since the
start of the titration. This parameter is only shown for Stop criterion =
time and Delay time = inf.
Titrino
Range
0 ... 999999 s
Selection off
Default value off
Endpoint 2
Note
Is activated only for EP1 with ≠ off.
on | off (Default value: off)
Check box for switching endpoint 2 on/off. If this is deactivated, then the
associated parameters will not be displayed.
EP2 with
Measured value for the second endpoint.
Range -200.0 ... 200.0 µA
Selection off
Default value off
For additional parameters for Endpoint 2, see Endpoint 1.