Metrohm tiamo 2.3 (process analysis) - Manual (Page 1021)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 5 Method
tiamo 2.3 (for Process Analysis) ￭￭￭￭￭￭￭￭ 1005
Designa-
tion Description
.LP.TEM Temperature for the last measuring point of the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.SLO Electrode slope of the sensor used for the command (in
mV for ISE sensors)
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
5.6.4.9.2 MEAS Conc - General/Hardware
Tab: Method ▶ MEAS Conc ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Input 25 characters
The general parameters for the device, the sensor and the stirrer are
defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead