Metrohm tiamo 2.3 (process analysis) - Manual (Page 522)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
506 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Gran evaluation
Note
This evaluation method is possible only with Titrando and 855.
Gran evaluation
on | off (Default value: off)
If this option is enabled, then titration curves will be evaluated in accord-
ance with the Gran Plot procedure(see Chapter 5.6.3.10.4, page 927).
Initial volume
Volume which must be present in the measuring vessel before the com-
mand is started.
Range 0.01 ... 9999.99 mL
Default value 50.00 mL
Lower limit
Value for the lower limit of the Gran evaluation range.
Range -2000.0 ... 2000.0 mV
Default value -2000.0 mV
Upper limit
Value for the upper limit of the Gran evaluation range.
Range -2000.0 ... 2000.0 mV
Default value 2000.0 mV
5.6.3.2.3.8 DET U - Additional measured values
Tab: Method ▶ DET U ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Input 25 characters
A maximum of 6 additional measured values can be defined on this tab
which can then be saved together in additional measured value columns
with the measured values present in the default settings: