Metrohm tiamo 2.3 (process analysis) - Manual (Page 1276)

5.6 Commands ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1260 ￭￭￭￭￭￭￭￭ tiamo 2.3 (for Process Analysis)
Note
In order that the event message from the SEND command can be han-
dled by the RECEIVE command, the RECEIVE command must be run-
ning and at the same time be able to process the message being sent.
If, for example, a SEND command in track A should start a KFT com-
mand in track B by means of Start titration, then track B must be run-
ning and the conditioning in the KFT command must already be fin-
ished (= Cond ok) at the time that the SEND command is being execu-
ted. Otherwise the command Start titration would be discarded with-
out a message.
Comment
Comment on the event message
Input 250 characters
Default value 'empty'
5.6.9.5 RECEIVE
5.6.9.5.1 RECEIVE - Overview
Dialog window: Method ▶ RECEIVE ▶ Properties... ▶ RECEIVE - 'Command name'
Command for awaiting event messages or status messages pro-
duced by commands.
Appearance
The command has the following appearance:
Parameters
The parameters for the command RECEIVE are configured in the follow-
ing dialog window:
￭ RECEIVE - Properties
Command variables
The following command variables are generated in the method run by the
command RECEIVE and can be used in formulas under the designation
'Command name.Variable designation':