FUJITSU F2MCTM-16LX - Manual (Page 376)

360
CHAPTER 18 8-/10-BIT A/D CONVERTER
18.5.1 Single-shot Conversion Mode
In the single-shot conversion mode, A/D conversion is performed sequentially from the
start channel to the end channel. The A/D conversion stops at the termination of A/D
conversion for the end channel.
■ Setting of Single-shot Conversion Mode
Operating the 8-/10-bit A/D converter in the single-shot conversion mode requires the setting shown in
Figure 18.5-1 .
Figure 18.5-1 Setting of Single-shot Conversion Mode
PAUS STS1 STRT Re-
served
STS0 BUSY INT INTE ADCS
0 0
MD1 S10 MD0
− − − − −
− − − − −
− D9 to D0 (Converted data stored)
CT1 CT2 CT0 ST1 ST2 ST0
ADCR
ADER5
bit15 14 13 12 11 10 9 bit8 bit7 6 5 4 3 2 1 bit0
ADSR ANS1 ANS0 ANE1 ANE0 ANE2 ANE3 ANS2 ANS3
ADER6
ADE15ADE14ADE13ADE12ADE11ADE10 ADE9 ADE8
ADE7 ADE6 ADE5 ADE4 ADE3 ADE2 ADE1 ADE0
: Setting 0 0
: Set the bit corresponding to pin to be used as analog input pin to 1.
: Used bit
: Undefined
−
0 0
Re-
served
Re-
served