Grass Valley Kalypso User Manual V.15.0 - Manual (Page 411)

Kalypso — User Manual 411
Fundamentals Tutorial
Preset Pattern
In this exercise you will create a preset pattern key using various patterns
and border effects.
1. Setup the switcher.
• If you just completed the exercise above, go to Step 3
• If you completed the exercise above previously, recall register 93.
With
Bank 9 selected, press 3 .
• If you haven’t done either of the above, clear the switcher by
recalling register 99 (press
Bank 9 , 9 ) and then set up the switcher
manually to the following state: on the PGM PST A bus,
on PGM PST B bus, on PGM PST Key 1, on
PGM PST Key 2. Delegate only Pgm Ps t in the Master E-MEM sub-
panel.
2. Make sure is on the PGM PST A bus, and is on the B bus.
3. You will now select on the PGM PST Key 3 bus. Do this by
holding down the PGM PST Alt Buses source select modifier button
( Figure 278 ) and selecting on the PGM PST K1/3 bus. This
selects a source you used previously as a background on the alternate
key bus used by Keyer 3.
Figure 278. PGM PST Source Select Modifiers
0618_01_126_r0
Source
Select
Modifiers
Key Key
Add
Add
Key Key
Drop
Drop
Key Key
Split
Split
Alt Alt
Buses
Buses
Un- Un-
Shift
Shift
Shift Shift Far Far
Side
Side
Near Near
Side
Side
Alt
Buses
PGM PST
Source Select
Modifiers