Grass Valley Kalypso User Manual V.15.0 - Manual (Page 246)

246 Kalypso — User Manual
Section 3 — System Operation
5. Touch the Cue button to enter the timecode ( Figure 185 ).
Figure 185. Timeline Events Menu, Cue Event Selected
6. Set up the Main panel to the desired state, making sure the DDR source
is not selected on the PGM PST A bus.
7. Learn this state to an E-MEM register as the first keyframe of the effect.
8. Go to a point later in your effect giving sufficient time for the clip to
load and cue. For example, to go three seconds in you can press
Go To Time , 3 , • , Enter .
9. Touch the Clear Events button in the Events pane to deselect the old
commands. This helps prevents accidental multiple load and cue
commands in the same effect.
10. Touch the Play button on the Timeline Events menu.
11. Set up your control panel to the desired state, including selecting the
DDR on the PGM-PST A bus.
12. Press Insert to add the keyframe information to the E-MEM register.
13. Go to a point later in your effect giving sufficient time for the desired
material in the clip to play. For example, for a 20 second clip that started
at three seconds, press
Go To Time , 23 , • , Enter .