Grass Valley Kalypso User Manual V.15.0 - Manual (Page 142)

142 Kalypso — User Manual
Section 3 — System Operation
User Preferences, and can be saved and instantly loaded for use at any time
(see File Operations
on page 155 ).
The factory default button mappings for the local panels
Button mappings of the Main panel and Local Aux panel are set at the
factory before shipment to the settings listed in
Table 4 (4-M/E systems)
and Table 5 (2-M/E systems).
If a Kalypso system’s NV memory is cleared, local panel button mappings
will revert to the 4-M/E factory default shown in
Table 4 .
Source Button Mapping
On the Kalypso system, each bank on the Main Panel can have its own
independent source to button mapping, if desired. The Local Aux panel can
also have different button mappings, as well as each Remote Aux panel.
Typically button mappings on the Main Panel are set the same, for oper-
ating simplicity. However, in some situations individual bank mapping can
be advantageous. For example, on a show with a large number of sources
you can place all the DDR and VTR sources on one bank, all the cameras on
another bank, etc., and then have direct access to any desired source. If you
use this feature, your system should be equipped with source name dis-
plays on all banks so the different sources can be identified.
Table 4. 4-M/E Factory Configured Source to Button Mapping
Panel Button Unshifted Shifted
Button 1 Black Test
Buttons 2-31 Source 2 - 31 Source 34 - 63
Button 32 Bkgd 1 Bkgd 2
Table 5. 2-M/E Factory Configured Source to Button Mapping
Panel Button Unshifted Shifted
Button 1 Black Test
Buttons 2-23 Source 2 - 23 Source 34 - 63
Button 24 Bkgd 1 Bkgd 2