Grass Valley Kalypso User Manual V.15.0 - Manual (Page 262)

262 Kalypso — User Manual
Section 3 — System Operation
/ E-MEM Prefs ), to make an assignment. Touch the R-MEM data pad, then
select the desired Enable button.
Once this assignment has been made, recalling an E-MEM register on the
Master E-MEM subpanel will recall that same number R-MEM register.
Learning an E-MEM register on the Master E-MEM subpanel will also learn
the same R-MEM register.
CAUTION Make sure the R-MEM enable group you choose is only enabled when you
actually need to use it during effect recalls. Confusing source selection button
changes can occur otherwise. Using E-MEM Auto Recall can help control
when groups are enabled.
Learning R-MEMs on the Main Panel
When R-MEM has been assigned to an E-MEM Enable button, learns can
be performed from the Menu panel as well as the R-MEM menu.
Note The Learn operation you will use erases any existing information in al the
enabled levels of the current E-MEM register.
1. On the Master E-MEM subpanel select the Enable button to which
R-MEM has been assigned. This enables R-MEM for the current effect
register.
2. Setup the desired R-MEM state.
a. Go to the R-MEM Router Select menu (accessed via R-MEM / Router
Select ) and select the router source to be used with each switcher
source.
b. Go to the R-MEM menu (touch the R-MEM category selection button)
and enable the desired switcher sources. Select Auto Recal l if you
want the ability to recall R-MEM settings for only the selected
switcher sources.
3. Press the Learn button on the Main panel Master E-MEM subpanel, then
press the Bank and Register keypad number of the desired register. This
will save the current R-MEM setting in the menu to the header area of
that E-MEM effect register and the first keyframe of the new effect will
be created. The corresponding R-MEM register in the menu will also be
updated.
Changing R-MEM on an Existing E-MEM Register
1. On the Master E-MEM subpanel recall the E-MEM register you wish to
change.
2. On the Master E-MEM subpanel select the Enable button to which
R-MEM has been assigned.