Grass Valley Kalypso User Manual V.15.0 - Manual (Page 402)

402 Kalypso — User Manual
Appendix A — Tutorials
9. Select the source select button on the PGM PST K2/K4 bus
below the K1/3 bus ( Figure 269 on page 399 ). On your system this
source will probably be named differently. For the tutorial this source
should be configured as a Luminance Key (using a video signal as key
fill without an accompanying key signal). Source Memory will
probably have automatically selected a Luminance Key in the Keyers
subpanel, and only the
Lum button should be illuminated. If the Fixed Lin
button is also on, or a different key type is selected, press only the Lum
button to select a Luminance Key.
10. Press the PGM PST Transition subpanel Key 2 button ( Figure 271 on
page 401 ). The Key 1 button will go off and you should now see
keyed over on the preview monitor.
11. Use the Clip/Clip Lo/Size and Gain/Clip Hi/Soft knobs to adjust clip and gain
of the Luminance Key. Note that a full range of clip and gain control is
available. Clip and Gain, rather than Clip Hi and Clip Lo was selected
when you configured the system for the tutorial. See Clip Hi and Clip Lo
on page 83 for background information about clip controls.
12. Press the Transition subpanel Key 1 and Key 2 buttons at the same time.
Both buttons will illuminate and both keys will appear on the preview
monitor. The Keyers subpanel will also be delegated to control the
highest numbered key that was just selected (
Key 2 ). Two keys have
been selected for the next transition.
13. Now select the source select button again on the PGM PST K1/
3 bus. The Keyers subpanel automatically delegates to that keyer, and
Source Memory remembers the last setting made for that key source so
only the
Fixed Lin button will be illuminated.