Grass Valley Kalypso User Manual V.15.0 - Manual (Page 249)

Kalypso — User Manual 249
Machine Control Operations
they should appear in the event list. An insert operation is reduced from
two button presses to only one.
1. Touch Extern Device , Event List to go to the External Device Event List
menu.
2. Touch the Insert button so its indicator is illuminated.
3. Scroll the Clip Browser and touch the first clip for the list. It will be
added to the Event List in the right pane, and the
Insert button legend
will change to Insert After .
4. Continue to select clips in the desired order with the Insert After button
on to build the rest of the Event List.
5. If you need to re-arrange the order of the clips in the Event List, use the
list editing buttons (
Move Up , Move Down , etc.). Remember to first select
the clip in the Event List where you wish the re-arrangement to occur
before you use these buttons.
6. When the Event List is complete, it can be used for your production
without saving it. The list will only reside in RAM, however, and so will
be lost if the Kalypso system is reset.
7. To save the Event List for reuse in the future, touch Save List , navigate to
the destination folder (creating a new one if desired), enter a name for
the list, and then touch
Save . This list can now
To Play a Video and Key Pair in Sync Using Device Links
The External Device Links menu is used to link devices so they can be con-
trolled together from the Machine Control subpanel. For example, two
DDR channels can be linked so they roll in sync, one playing the video
signal and the other playing the key.
When loading or cuing linked devices, load and cue the primary device
first. This also loads and cues the linked devices. Next, load and cue any
linked devices individually. It is also helpful to set a Mark in point on each
device so that when the primary device is cued, all devices cue up to the
appropriate frame for subsequent sync roll.
1. Create a video clip and a key clip and set cue points so they are in sync.
2. Create a device link in the External Device Links menu. The device that
will play the video clip is the primary device and the device for the key
signal is the linked device. Enable that link.
3. Using the Machine Control subpanel, load the video clip on the
primary device. That clip will load and cue on both devices.
4. Delegate the Machine Control subpanel to the linked device and load
the key clip. The key clip will cue on that device.