Grass Valley Kalypso User Manual V.15.0 - Manual (Page 390)

390 Kalypso — User Manual
Appendix A — Tutorials
11. Set the Auto Transition rate back to 1 second:
Trans Rate , Auto Trans , 1 , • , Enter
12. Press Preset Black , then press Auto Trans . The mix transition will go to
black instead of the source selected on the B bus. A Preset Black
transition requires two button presses to complete. Press
Auto Trans
again to complete the transition. The light on the Preset Black button
will go off, automatically exiting the mode.
13. Again press Preset Black and then press Auto Trans . While in black, select
on the B Bus. Now press Auto Trans and the mix transition will
complete to the newly selected source. You can change to any source
when midway through a Preset Black transition.
Wipe Background Transitions, Transition Preview, Wipe Borders
In this exercise you will perform wipe transitions, use transition preview,
create a wipe border, and route video to a wipe border using a Utility bus.
1. Set up the switcher.
• If you just completed the exercise above, go to Step 2 . below.
• If you completed the exercise above previously, make sure the
Auto Recall button in the Master E-MEM subpanel is illuminated and
press Bank 9 , 9 to recall register 99 to clear the system. Then press 0 to
recall the ending point of the first exercise. If this doesn’t return the
system to its previous state, the registers were overwritten. Load the
effects from removable media (see
page 382 ) and then recall them.
• If you haven’t done either of the above, set up the switcher manu-
ally to the following state:
on the PGM PST A bus, on PGM PST B bus. Delegate
only Pgm Pst in the Master E-MEM subpanel.
2. Make sure Pgm Pst is selected in the Preview subpanel.