Grass Valley Kalypso User Manual V.15.0 - Manual (Page 236)

236 Kalypso — User Manual
Section 3 — System Operation
To Delegate Machine Control with a Source Select Button Hold Down:
A machine control device can be temporarily delegated to the Machine
Control subpanel to that device.
1. Hold down the source selection button mapped to a machine control
device on any Kalypso System Main panel bus. While that button is
held down, Machine Control subpanel commands can then be issued to
that device.
2. Release the source select button to return the Machine Control
delegation to the bus last delegated for machine control.
Machine Control Commands
Once the machine control subpanel is delegated to a source, commands can
be issued to that device.
Basic Commands
The Play , Stop , Rewind , Fast Fwd , and Cue buttons in the subpanel send these
commands to the selected device.
Jogging a Clip or VTR
Holding down the Stop button while pressing the Rewind or Fast Fwd buttons
jogs one frame forward and backward.
Selecting and Loading Clips
Pressing the Prev Event and Next Event buttons scrolls through a clip list
reported by the device. When a clip that is not currently loaded is displayed
in the readout (the
Cue/Load button will go low tally), pressing Cue/Load loads
that clip on the device.
Changing Delegations
When the machine control subpanel delegation changes to a different
device, the first device continues to do what it was last commanded to do.
As a simple example, a playing device will continue to play as the delega-
tion changes. This also applies to mode selections like
Auto Start , which will
start a device when it goes on air. You can delegate the Machine Control
subpanel to a device, turn its
Auto Start on, then change the panel delegation.
The device will still roll when it goes to air.