Grass Valley Kalypso User Manual V.15.0 - Manual (Page 368)

368 Kalypso — User Manual
Appendix A — Tutorials
This tutorial is designed to be run sequentially from beginning to end. You
are directed to save files periodically to removable media. If you need to
stop the tutorial, you can later resume from where you left off by reloading
the files.
Requirements
For this tutorial the Kalypso system must be equipped with at least the fol-
lowing:
• One PGM monitor,
• One switched preview monitor, set to look ahead preview.,
• Three different video only sources. For this tutorial these sources will
be referred to as
, , .,
Note Your video and key sources will have names specific for your facility. To make
this tutorial easier for beginning operators, you may want to temporarily con-
figure the nicknames of these sources to match the tutorial names.
• One Linear Key source (preferably a Character Generator with shaped
video and key signals). For this tutorial it will be referred to as
,
• One Luminance Key source (video only, with a high contrast image).
For this tutorial it will be referred to as
,
• A formatted Zip disk or USB stick, for saving configuration and effect
files, and
• Kalypso system hardware must be completely installed and properly
configured and be running the latest software.
Suite and User Configuration
Note This tutorial assumes other users of your Kalypso system have already
created and saved their own Suite and User Preference settings, and have
saved any effects they plan to use in the future. You may want to confirm that
the last users of the system have saved their files.
For this tutorial you will set some Kalypso system configuration settings to
factory defaults, and may need to make other configuration changes to
ensure the procedures work as described. After you are done working on
the tutorial, other users can reload their own saved files to restore the
Kalypso system to their desired operating condition.
Change Suite Preference Settings
In this exercise you will change the Default Keyframe setting (one compo-
nent of Suite Preferences), and make sure Source Memory is on. Changes