Grass Valley Kalypso User Manual V.15.0 - Manual (Page 334)

334 Kalypso — User Manual
Section 3 — System Operation
acts as the key cut signal for the keyers selected. Priority of the layers is set
using normal keyer priority controls.
Figure 229. M/E Mode, Split Layered
Split Layered Mode Menu Controls
The Layered pane below the Mode pane is enabled only when the Split
button is selected in the Mode pane. Selecting Split , then selecting the
Primary ( Pri ) button sets the Primary partition to Layered mode. Likewise,
selecting the Secondary ( Sec ) button sets the Secondary partition to Layered
mode.
Main Panel Controls in Split Layered Mode
The Pri and Sec Main Panel buttons behave the same as they do in Split
mode, with the exception that background bus selections are not used for
the partition that is in Layered mode. The keyer source selections are
allowed in Layered mode for the keyers that are assigned to the primary or
the secondary partition delegated.
A/B bus selections do not feed backgrounds for a primary partition that is
in Layered mode.
U1/U2 bus selections do not feed backgrounds for a secondary partition
that is in Layered mode, but they can be used for key masks, video in bor-
ders, wipe pattern source, etc.