Grass Valley Kalypso User Manual V.15.0 - Manual (Page 152)

152 Kalypso — User Manual
Section 3 — System Operation
Source Patching Procedure
1. Touch Daily Setup , Suite Prefs , Source Patch to go to the Source Patch menu
( Figure 127 ).
Figure 127. Source Patch Menu
2. Select the Logical ID of the source you wish to change by either:
• Scrolling through the list with the Logical Source soft knob. This
changes the current selection.
• Scroll through the list with the scroll bar on the right. This scrolls the
list without changing the current selection. When the desired
source appears on the menu, touch it’s Logical ID button to select it.
3. Name the source by touching the Logical Name and/or Logical Nickname
data pads and entering the desired names using the popup keypad (see
Naming Guidelines
on page 149 ).
4. If you wish to change the source patching, select an Engineering source
to be associated with the currently selected Logical source with the
Engineering Source soft knob (see Using Source Patching for Effects
Portability
on page 150 ).