Grass Valley Kalypso User Manual V.15.0 - Manual (Page 321)

Kalypso — User Manual 321
Shot Box Option Operation
The Shot Box panel must be reset to restore communication. The Shot Box
can be reset by cycling power to the unit, or via keystrokes on the panel.
To Reset the Shot Box from the Panel:
1. Press Page to enter the page selection mode.
2. Press and hold the Run and Auto Run buttons simultaneously until the
readout display goes blank.
3. Release the Run and Auto Run buttons.
Delegation Buttons
The three buttons to the left of the display delegate the Shot Box panel to
M/E 1, M/E 2, or M/E 3, as labeled, or to Master E-MEM. When one
button is illuminated, that M/E is subject to control. When all three buttons
are off, the panel is delegated to Master E-MEM. These buttons are mutu-
ally exclusive, such that pressing one button turns off any other currently
selected button, and pressing a currently selected button turns it off, dele-
gating the panel to Master E-MEM.
Following standard Kalypso system operation, when the Shot Box is dele-
gated to Master E-MEM with Auto Recall off, the Enable buttons on the
Master E-MEM panel control what E-MEM levels are affected by a Shot Box
register recall. When Auto Recall is on, the levels affected can vary with
each Shot Box register recall, depending on what levels were enabled when
the effect was learned.
Page Button
The Page button is used to gain access to five pages of 20 registers for each
of the three M/Es and PGM/PST. Each page is accessed by pressing the
Page button, then selecting the page number ( 0 - 4 ).
The Page button is also used for resetting the panel and displaying versions.
Table 14. Page Button Registers
Buttons
Pressed
Registers
Accessed
Page 0 0 - 19
Page 1 20 - 39
Page 2 40 - 59
Page 3 60 - 79
Page 4 80 - 99