Grass Valley Kalypso User Manual V.15.0 - Manual (Page 310)

310 Kalypso — User Manual
Section 3 — System Operation
enable buttons listed in Table 11 . These assignments can be changed from
the E-MEM Prefs menu.
Still Store E-MEM Parameters
The following Still Store settings are keyframeable:
• Item load from the current folder to each Still Store output,
• Each Still Store output Video/Key Pair state (on or off),
• Position,
• Crop,
• Mark Points,
• Freeze Frame Mode, and
• Start at KF trigger.
Inserting or modifying a keyframe in an effect will save the above settings
on that keyframe for that E-MEM level. These settings will be enacted later
when the E-MEM register is recalled or run.
S-Linear path controls are applied to all interpolated Still Store E-MEM
operations. Note that positioning and cropping is on line and pixel bound-
aries. These aspects of an image cannot be moved perfectly smoothly with
the Still Store (if smooth motion is desired use a Transform Engine).
E-MEM Clip Playback
Each time a Still Store Start at KF trigger command is encountered in an
effect, the clip is cued and plays from that cue point. You must make sure
effect keyframes that follow the initial start trigger within the duration of
the clip do not have
Start at KF on, or the clip will be recued. Clips cannot be
played backwards or paused.
If you want to create an effect that cues and plays a clip when an EMEM
register is recalled, you can turn the
Start at KF button on and then learn a
new E-MEM register. This puts the trigger on the first keyframe of the
effect. As with all E-MEM Still Store operations, the item will need to be
cached in advance for proper playback.
Table 11. Default Still Store Output Channel E-MEM Assignments
Still Store
Output Channels
E-MEM
Enable Button
Ch1, 2 SS A
Ch 3, 4 SS B
Ch 5, 6, 7, 8 SS C