Grass Valley Kalypso User Manual V.15.0 - Manual (Page 192)

192 Kalypso — User Manual
Section 3 — System Operation
E-MEM Learn Modify
Each E-MEM register contains header information, along with keyframe
data. This header information applies to the entire effect and is not key-
framable. Register header information includes:
• E-MEM enable group button selections (for Auto Recall)
• Effect Dissolve state (on or off)
• Effect Dissolve rate (seconds, frames, field)
• DPM effect number
When an effect is edited in the standard manner (Insert , Mod , Mod All ), only
keyframe data is affected. The header information does not change. In a
standard
Learn operation, all existing keyframe data is overwritten with a
single keyframe, and new header information is saved.
Release 15.0 supports Learn Modify, which you can use to update E-MEM
register header information without changing keyframe data. To use this
feature, select the state of the desired header information, then press
Learn ,
Mod . Examples are presented below:
To change the enable groups associated with Auto Recall:
Press Auto Recall so it is on, select the desired Master E-MEM Enable buttons
for the desired groups of levels, then press Learn , Mod .
To change the Effect Dissolve rate of the current effect:
Press Effect Dis so it is on, then press Trans Rate , (type seconds, frames, fields),
Enter , Learn , Mod .
To change DPM effect number:
Select a different effect on the external DPM, then press Learn , Mod .
Editing Path Control
Path control determines how interpolation is performed through key-
frames. S-Linear, Linear, and Curve path types are supported, in addition
to Path Hold. These path types provide fine control of the dynamics of the
effect. See Path Control
on page 117 for background information.
To Change Path Control Values in an Effect:
1. Move to the location in the effect that you wish to change.
2. Go to the Path Types menu ( E-MEM , Path or Timeline, Path ) and delegate
the desired Level(s), Sublevel(s), and Group(s). In Figure 156 the keyer
wipe of Keyer 1 of M/E 1 has been selected for path control editing.