Grass Valley Kalypso User Manual V.15.0 - Manual (Page 231)

Kalypso — User Manual 231
Bus Linking
Source Associations
Selecting a button in the Controlling Bus pane delegates the Linked Bus
pane to that Controlling source (
Figure 174 on page 229 ). Selecting a button
in the Linked Bus pane associates that new Linked bus source to the cur-
rently selected Controlling bus source. The
(none) selection chooses no
source link. A complete Link Mapping table is built by selecting each
source in the Controlling Bus list, then selecting the appropriate source in
the Linked Bus list.
Two soft knob controls on the upper right can be used to select sources to
be associated. The top knob selects the source in the Controlling Bus pane,
and the second knob selects the source in the Linked Bus pane.
The Lock button changes the behavior of the Linked Bus scrolling list. When
Lock is Off, selecting a source in the Controlling Bus pane will scroll that list
so the Linked source is visible in the pane. When Lock is On, selecting a
source in the Controlling Bus panel the list will not scroll. The selected
Linked source may not appear in the pane. This permits the rapid selection
of adjacent Linked Bus sources without having to continually re-scroll that
list.
Link Management
Individual bus links are enabled and disabled with the Link Enable button in
the Controlling bus pane. When enabled, commands will be sent from the
Controlling bus to the Linked bus, provided all links are not inhibited (see
below).
Other controls on this menu can be used to manage bus links.
Bus Hold Inhibits Links – This control affects the behavior of the Main panel
Hold button for all Linked buses. When Bus Hold Inhibits Links is On and the
Hold button on a Linked bus is also On, that Linked bus will ignore bus link
commands and will not change sources when Controlling bus sources
change. Note that the
Hold button retains its existing functionality, keeping
that bus from changing sources when an E-MEM register is recalled.
Inhibit All Links – Overrides all Link Enable settings to disable all active bus
links. This does not change the individual Link Enable settings, however.
Turning Disable All Links off will re-enable any bus links with Link Enable on.