Grass Valley Kalypso User Manual V.15.0 - Manual (Page 405)

Kalypso — User Manual 405
Fundamentals Tutorial
18. Learn this effect to register 91. Make sure the Auto Recall button is
illuminated and only the Pgm Pst enable button is on (all other enable
buttons off). Then with Bank 9 still selected, press:
Learn , 1
19. With the effect saved, you can go back and experiment on your own
with these and other controls.
Key Transitions
In this exercise you will transition keys on and off and set key transition
rates.
1. Setup the switcher.
• If you just completed the exercise above, go to Step 2 . below.
• If you completed the exercise above previously, make sure the
Auto Recall button in the Master E-MEM subpanel is illuminated and
press Bank 9 , 9 to recall register 99 to clear the system. Then press 1 to
recall the ending point of the first exercise. If this doesn’t return the
system to it’s previous state, the registers were overwritten. Load
the effects from removable media (see
page 382 ) and then recall
them.
• If you haven’t done either of the above, clear the switcher by
recalling register 99 (press
Bank 9 , 9 ) and then set up the switcher
manually to the following state:
on the PGM PST A bus, on PGM PST B bus, on
PGM PST Key 1, on PGM PST Key 2, only Key 1 selected for
the next transition. Delegate only Pgm Ps t in the Master E-MEM sub-
panel.
2. Select Pgm Pst on the Preview subpanel, if necessary.
3. If it is not already selected, press the Mix transition type button on the
PGM PST Transition subpanel.
4. Observing the program monitor, press the Auto Trans button in the
PGM PST Transition subpanel. will mix on the program monitor
over the existing background in one second (if the transition rate
hasn’t been changed). The On indicator below the Key 1 transition
button illuminates and the Key 1 Cut button will also illuminate. The key
is on-air.