Grass Valley Kalypso User Manual V.15.0 - Manual (Page 322)

322 Kalypso — User Manual
Section 3 — System Operation
Register Buttons
The 20 register buttons (labeled 0-19) correspond to the E-MEM registers
selected for the delegated bank and page. Pressing one of these buttons
selects that register for use. If
Auto Run is on, the register will also run auto-
matically.
Recalling Registers
To recall a different register from the same page range, simply press the 0 -
19 Shot Box button for the desired register.
To recall a register from a different page range, first specify the page and
then the register number (
Table 15 ).
Once a page is selected, subsequent registers can be recalled from that page
range with a single Shot Box register button press.
Run Buttons
The Run button runs the selected Master E-MEM register, just like pressing
the Master E-MEM Run button on the Main panel. The Run button on the
Shot Box does not light for the duration of the effect, as the Run button does
on the Main panel (the Editor protocol does not support this). Instead, the
Run button lights for one second to indicate the command has been sent.
The Auto Run button works the same as on the Main panel. When on,
E-MEMs will run automatically when recalled from the Shot Box.
Note The Shot Box Run and Auto Run buttons do not work when M/E 1, 2, or 3 is
delegated. The Kalypso system currently supports effect run only on Master
E-MEM.
Readout Display
The Shot Box Readout display shows which bank and page is currently
selected, and which register was last selected from the shot box panel.
Table 15. Examples of Recalling Registers from Different Pages
Register Button Presses
5 Page, 0, 5
15 Page, 0, 15
25 Page, 1, 5
79 Page, 3, 19
80 Page, 4, 0