Grass Valley Kalypso User Manual V.15.0 - Manual (Page 180)

180 Kalypso — User Manual
Section 3 — System Operation
To Run an Effect
With Auto Run Off
1. Recall the desired effect.
2. Press Run .
With Auto Run On
1. Recall the desired effect. The effect will run as soon as it is recalled.
E-MEM Sequences
To Learn a Sequence of Registers
1. Press Learn , Seq .
2. Press the bank and register keypad buttons of the desired registers in
the order you wish them to run.If you wish you can add a delay time at
each register by pressing
Trans Rate and entering a time value.
3. Press Learn .
To Play a Sequence of Registers
1. Press Seq .
2. Press the bank and register keypad button of the starting register.
To Break a Sequence
1. Press Learn , Seq .
2. Press the bank and register keypad button of the register to end the
sequence.
3. Press the same bank and register button you just pressed.
Basic Effect Editing
Effect editing involves changing work buffer values using panel and/or
menu controls, then applying these values to the effect. This discussion
concerns basic effect editing, using the Master Timeline for the examples.