Grass Valley Kalypso User Manual V.15.0 - Manual (Page 263)

Kalypso — User Manual 263
Router Interface Operation
3. Setup the desired R-MEM state.
a. Go to the R-MEM Router Select menu (accessed via R-MEM / Router
Select ) and select the router source to be used with each switcher
source.
b. Go to the R-MEM menu (touch the R-MEM category selection button)
and enable the desired switcher sources. Select Auto Recal l if you
want the ability to recall R-MEM settings for only the selected
switcher sources.
4. On the Master E-MEM subpanel press Learn , Mod . The R-MEM setting in
the menu will be updated to the header area of that E-MEM effect
register. Keyframes existing in the effect will remain unchanged. The
corresponding R-MEM register in the menu will also be updated.
Loading R-MEM Registers
Like E-MEM registers, loading an R-MEM register from disk does not affect
the current work buffer. If an effect is loaded in the work buffer and that
register number containing different settings is loaded from disk, the reg-
ister will need to be recalled before any changes in state occur.
Empty R-MEM Keyframes
If the R-MEM enable button is on when keyframes on other levels are
inserted into the effect, R-MEM keyframes containing effectively no data
will also be added to the effect and appear on the Timeline menu. These
keyframes are only system artifacts and do not influence the running of the
effect.