Grass Valley Kalypso User Manual V.15.0 - Manual (Page 247)

Kalypso — User Manual 247
Machine Control Operations
14. Touch the Clear Events button in the Events pane to deselect the old
commands.
15. Touch the Stop button.
16. Set up your control panel to the desired state, including selecting an
alternate source on the PGM-PST A bus.
17. Press Insert to add the keyframe information to the E-MEM register.
18. Touch the Clear Events button in the Events pane to deselect the
commands.
19. Recall and run the register. The clip will load and cue, be taken on-air,
play automatically, be taken off-air and then stop.
To Play a Video and Key Pair of Sources in Sync
1. Follow the Preparation for Control procedure on page 243 .
2. Besides Misc 2 (or whichever button your machine control device has
been associated with), make sure PGM PST level is also enabled and
delegated for editing on the Master E-MEM subpanel.
3. In the Timeline Events menu, delegate the device to be used for the
video signal, and select
Load and Cue events for it. Do not add these
events to a keyframe yet.
4. Delegate the device to be used for the key signal, and select Load and Cue
events for it.
5. Set up the Main panel so PGM PST Key 1 is not on-air and the DDR
source is not selected on the PGM PST A bus.
6. Add this to the first keyframe of the effect by pressing Insert .
7. Go to a later point in your effect giving sufficient time for the clips to
load and cue. For example, press
Go To Time , 3 , • , Enter .
8. Select PGM PST Key 1 in the Next Transition area so it will mix on, and
setup a split key with the two DDR channels.
9. Touch the Clear Events button in the Events pane to deselect the old
commands.
10. Delegate the device playing the video and select a Play event for it.
11. Delegate the device playing the key and select a Play event for it.
12. Add these events to the same keyframe of the effect by pressing Insert .
13. Touch the Clear Events button on the Timeline Events menu to un-select
the commands.