Grass Valley Kalypso User Manual V.15.0 - Manual (Page 386)

386 Kalypso — User Manual
Appendix A — Tutorials
Figure 259. Pgm Pst Source Select Modifiers
7. Hold down the Shift button in the PGM PST Source Select Modifier area,
below the M/E Status Display ( Figure 259 ). The first source selection
button now reads Test instead of Black (if factory default source
mappings are used for those buttons). If other shifted sources have been
mapped to buttons, their names will also appear on the rest of the PGM
PST bus A. For example, system
BG 2 may appear in place of BG 1 on the
last button on the right (factory default source mapping). For Release
15.0, the buttons for the source select buttons currently selected with
the opposite shift preference will also blink. In this case, all the
unshifted sources will blink when the
Shift button is held down.
8. While still holding down the PGM PST Shift button, press the Test source
selection button on the PGM PST A bus. The test signal instantly
appears on the program monitor. This is a hot cut to a shifted source.
The M/E status display reports
Test for background bus A. When you
release the Shift button, the source names will revert to their unshifted
sources. For Release 15.0, only the shifted source you just selected will
blink, because it was selected with the opposite shift preference.
9. Hold down the PGM PST Unshift button ( Figure 259 ). The source name
display will show the unshifted Black source. While holding down the
Unshift button, press the Black source selection button and its signal will
appear on the program monitor. Release the Unshift button and Black
remains on the source name display with its button high tally.
10. Select on PGM PST A and on PGM PST B.
11. You will now Learn the current setup to register 90. If the Auto Recall
button in the Master E-MEM subpanel is not illuminated, press it to
turn it on. Press the
Sel All button in the Master E-MEM subpanel so all
the level group buttons go off, and then press only the Pgm Pst enable
button. This delegates only that level for the next action. Now learn the
register by pressing:
Learn , Bank 9 , 0
12. If you are stopping the tutorial at this point, save your effects to
removable media for use later (see
page 381 ).
0618_04_139_r0
Source
Select
Modifiers
Key Key
Add
Add
Key Key
Drop
Drop
Key Key
Split
Split
Alt Alt
Buses
Buses
Un- Un-
Shift
Shift
Shift Shift Far Far
Side
Side
Near Near
Side
Side
Un-
Shift
Shift
PGM PST
Source Select
Modifiers