Grass Valley Kalypso User Manual V.15.0 - Manual (Page 341)

Kalypso — User Manual 341
Resource Sharing
Configure Control Surfaces
Control Surface definitions are part of Engineering Setups, apply to the
entire Kalypso system, and so affect both suites.
1. Logon as the EIC using the Menu panel associated with what will be
Suite 1.
2. Touch Eng Setup , System , Suite Def to go to the Suite Definition menu
( Figure 232 ).
Figure 232. Suite Definition Menu, Initial Display
CAUTION When logged in as the EIC, changes made to the Kalypso Node scrolling list
of IP Addresses are sent to the Video Processor frame as they are entered.
The existing IP connections used by the frame are retained temporarily, but
resetting that node’s device or the frame imposes the new address and the
previous connection will be lost.
3. Enter the IP addresses of all Kalypso system components to be used as
nodes for Resource Sharing with the IP Address data pads in the
scrolling list. It is essential this information (at least for the Menu panel
used for configuration) is entered before the frame is rebooted in Multi
Suite mode, to ensure access to the system from that Menu panel. In
Multi Suite mode panels will not connect to the frame unless their IP
addresses are in the Node list.