Grass Valley Kalypso User Manual V.15.0 - Manual (Page 377)

Kalypso — User Manual 377
Fundamentals Tutorial
Clear the Kalypso System
The Kalypso system controls should be placed in a known state for this
tutorial. This is accomplished by clearing the Kalypso system’s work buffer
to the Default Keyframe (which has been set to factory settings). You will
learn what settings are affected by clearing the work buffer, and what panel
controls are unaffected. You will also set all the buses to black, and save this
entire state to an E-MEM.
1. Press the Sel All button in the Master E-MEM subpanel ( Figure 249 ) so
all the Enable buttons are illuminated. If all the levels were already
enabled, pressing the button turns them all off. If this occurs, press the
button again to enable all the levels. With all the Enable buttons
illuminated, all the E-MEM levels are enabled for the next action.
Figure 249. Master E-MEM Subpanel
0618_02_120_r0
Master E-MEM
L0 23 EffectName
Put Put
Eff
Eff
Get Get
Eff
Eff
Go To Go To
Time
Time
Knob Knob
Set
Set
Level Level
Start
Start
KF KF
Time
Time
KF KF
Dur
Dur
Go To Go To
KF
KF
Trans Trans
Rate
Rate
Eff Eff
Dur
Dur
Sel Sel
All
All
M/E M/E
1
M/E M/E
2
M/E M/E
3
Ind Ind
Run
Run
Auto Auto
Recall
Recall
Dele- Dele-
gates
gates
Misc Misc
1
Misc Misc
2
Misc Misc
3
Misc Misc
4
Misc Misc
7
Misc Misc
6
Misc Misc
5
Pgm Pgm
Pst
Pst
Auto Auto
Run
Run
S S S S
A
S S S S
C
S S S S
B
Undo Undo
•
0 Bank Bank
0
+/– /–
Bank Bank
4
Bank Bank
9
Clear Clear
Entry
Entry
Bank Bank
3
Bank Bank
2
Bank Bank
1
Bank Bank
6
Bank Bank
5
Bank Bank
7
Bank Bank
8
Trim Trim
Detent Detent
Enter Enter
Effect Effect
Dis
Dis
Seq Seq
Lock Lock
Learn Learn
Bank Bank
DPM DPM
7 8 9
4 5 6
1 2 3
Master E-MEM
Subpanel
Sel
All
Bank
9
Auto
Recall
Enable Buttons (15)
9