Grass Valley Kalypso User Manual V.15.0 - Manual (Page 313)

Kalypso — User Manual 313
Multi-Delegate Transform Engines Operation
on the menu. This is considered the master Transform Engine for display
purposes.
When a feature (like Drop Shadow or Glow) in another Transform Engine
menu is active, the name of the menu category selection buttons will be
underlined. If that feature is ON for one or more of the delegated TEs but
not for all, the underline will be broken.
As before, parameter changes made by entering values in datapads are
absolute, while parameter changes made with the soft knob are relative
Main Panel and Menu Panel Delegation Interactions
Transform Engine delegation operations performed on the Transform
Engine subpanel of the Main panel can affect the delegations on the Menu
pane (see bullet items below), but the reverse is not true. Delegation button
tally lights on the Main panel will not change when delegations are
changed with the Transform Engine menu. The joystick and other Main
panel button controls will only apply to those Transform Engines that have
been delegated using the Main panel, even if multiple Transform Engines
have been delegated using the Transform Engine Menu.
• If Transform Engine delegations are changed using the Main panel
when the Transform Engine menu
Multi Select button is On, multiple
delegations will be accepted by the Menu. The last TE delegated from
the panel becomes the new master (the master can be changed at the
menu).
Note When Multi Select is On and TEs are delegated from the panel
to the current selection in the menu, previously delegated TEs
are not deselected.
• If Transform Engine delegations are changed using the Main panel
when the Transform Engine menu
Multi Select button is Off, only the last
touched Transform Engine delegation will be accepted by the Menu.
It has always been possible to delegate multiple Transform Engines in the
same M/E for control on the Main panel, by holding down more than one
delegation button in the Transform Engine subpanel. This feature is
retained, but the existing limitation that the Transform Engines must be in
the same M/E remains in force. If you wish to control Transform Engines
in different M/Es, use the Transform Engine Menu. If you want to control
multiple M/Es in the same M/E, you can use either the Main panel or the
Menu.