Grass Valley Kalypso User Manual V.15.0 - Manual (Page 389)

Kalypso — User Manual 389
Fundamentals Tutorial
6. You will now change the Auto Transition rate to 2 seconds. Press
Trans Rate in the Master E-MEM subpanel ( Figure 261 ). The Auto Trans
and Key Mix buttons will flash, indicating you should pick one for a
rate change. Press the
Auto Trans button, and then enter the following on
the Master E-MEM keypad:
2 , • , Enter
The entry format is ( sec • frame • field ). In this case the • specifies sec-
onds. Values entered without a • are interpreted as frames.
Figure 261. Master E-MEM Subpanel
7. Press the Auto Trans button in the PGM PST subpanel ( Figure 260 on
page 388 ). The mix transition to now takes two seconds.
8. Press the Auto Trans button and one second later press it again. The
second press stops the transition midway. Press Auto Trans again to
resume the transition.
9. Set the Auto Transition rate to 10 frames:
Trans Rate , Auto Trans , 1 , 0 , Enter
When no • is used, frames are entered by default.
10. Press Auto Trans and observe the quick mix transition.
0618_02_103_r0
Master E-MEM
L0 23 EffectName
Put Put
Eff
Eff
Get Get
Eff
Eff
Go To Go To
Time
Time
Knob Knob
Set
Set
Level Level
Start
Start
KF KF
Time
Time
KF KF
Dur
Dur
Go To Go To
KF
KF
Trans Trans
Rate
Rate
Eff Eff
Dur
Dur
Sel Sel
All
All
M/E M/E
1
M/E M/E
2
M/E M/E
3
Ind Ind
Run
Run
Auto Auto
Recall
Recall
Dele- Dele-
gates
gates
Misc Misc
1
Misc Misc
2
Misc Misc
3
Misc Misc
4
Misc Misc
7
Misc Misc
6
Misc Misc
5
Pgm Pgm
Pst
Pst
Auto Auto
Run
Run
S S S S
A
S S S S
C
S S S S
B
Undo Undo
•
0 Bank Bank
0
+/– /–
Bank Bank
4
Bank Bank
9
Clear Clear
Entry
Entry
Bank Bank
3
Bank Bank
2
Bank Bank
1
Bank Bank
6
Bank Bank
5
Bank Bank
7
Bank Bank
8
Trim Trim
Detent Detent
Enter Enter
Effect Effect
Dis
Dis
Seq Seq
Lock Lock
Learn Learn
Bank Bank
DPM DPM
7 8 9
4 5 6
1 2 3
Master E-MEM
Subpanel
Trans
Rate
Keypad