Grass Valley Kalypso User Manual V.15.0 - Manual (Page 252)

252 Kalypso — User Manual
Section 3 — System Operation
Router control panels can also protect router destinations from being
changed by other control panels. A protected router destination cannot be
changed by a different control panel, but may be changed by the panel that
set the protection. Protections help prevent inappropriate router source
changes. The Kalypso system can be considered a type of router control
panel, and so the Kalypso system can protect router destinations. Kalypso
system router protect commands are applied to all router levels.
The names of router sources appear on the Kalypso system source name
displays. These names originate from the router system, and their text
cannot be changed from the Kalypso system. If a routed Kalypso source has
no connection to the router, an
X appears in place of the router source name.
If the router connection exists, but no source has yet been selected for that
destination (which can occur during bootup),
No Src appears.
Features
• Interfaces to the Grass Valley SMS 7000 routing system.
• Kalypso system configuration of routed Kalypso sources.
• Names of router sources are shown on Kalypso panel source name dis-
plays.
• Router source selection control via the Kalypso Local Aux panel (or
Local Aux subpanel on 2-M/E systems), Main panel, and Menu panel.
• Protection types (None, Protect, and On Air).
• R-MEM control (see page 258 ).
Local Aux Panel Router Interface Operation
Note Router interface operation becomes available after the Kalypso system and
the external router have been properly configured. See the Kalypso Installa-
tion and Service Manual for additional information.